Answerthe first question
Pick2 of the following questions below and answer them in a question/answer format.
Writea 200-300 answer for each question chosen.
Citea minimum of 3 peer-reviewed, scholarly, or similar references.
What is the Statement on Standards for Attestation Engagements 16 (SSAE 16)? Why is it important to an outsourcing service provider?
Research Proposal On:Obesity rate in Australia, How much time Australian spent on physical activities? And Is it a personal responsibility or junk food is the main reason.Should be 1000 words
During Week 1 of the course, you will be selecting the bank of your choice in a non-graded discussion topic. The selections are on a first-come, first-served basis, so until you have signed up for your bank, and are sure that no one has chosen the same bank, do not start working on this course project! From there, you will
access the financial actuals. That is, historical financial data for the past five years for the bank of your choice, as well as your banks competitor.
This may be taken from the commercial banks web site, or from the SEC web site.
develop a Microsoft Excel 2007 spreadsheet model using data given in the Statement of Financial Position. This should include
the balance sheet;
income statement; and
five to 10 common industry-specific financial ratios for both your selected commercial bank and its competitor.
given your Microsoft Excel spreadsheet, and the information it yields, write a report which discusses your commercial banks strengths and weaknesses.
This report must be written using the Microsoft Word 2007.
access the prevailing rates set by the Federal Reserve Board.
Prepare a chart and analyze your selected commercial banks historical profitability with the Federal Reserve interest rates over the past five years.
Discuss how these rates affected your banks profitability.
read the Annual Report of your selected commercial bank. Answer and discuss the following:
What is the announced mission, and future direction, as stated by the banks Chief Executive Officer?
Is your commercial bank in a good financial position to achieve those objectives?
prepare a forecast of your selected banks projected profitability (You forecast this!).
Assume that the Federal Reserve Board holds the interest rates as is or constant.
Discuss the impact this constant interest rate would have on three years of your banks profitability.
submit both the Microsoft Word 2007 document, as well as a Microsoft Excel 2007 spreadsheet files, in Week 7 to your dropbox. All the work should be properly cited in your paper per Keller policy, and a reference page should be included at the end of your Word document.
On the correctness, Cognitive system of the Thurstone Word Fluency Test
Skylights or “roof windows” are commonly used in homes and manufacturing facilities since they let natural light in during day time and thus reduce the lighting costs However, they offer little resistance to heat transfer, and large amounts of energy are lost through them in winter unless they are equipped with a motorized insulating cover that can be used in cold weather and at nights to reduce heat losses. Consider a 1-m-wide and 2.5-m-long horizontal skylight on the roof of a house that is kept at 20°C. The glazing of the skylight is made of a single layer of 0.5-cm-thick glass (k = 0.78 W/m.K and ε = 0.9). Determine the rate of heat loss through the skylight when the air temperature outside is -10°C and the effective sky temperature is -30°C. Compare your result with the rate of heat loss through an equivalent surface area of the roof that has a common R-5.34 construction in SI units (i.e., a thickness-to-effective-thermal-conductivity ratio of 5.34 m2.K/W). Evaluate air properties at a film temperature of -7°C and 1 atm pressure. Is this a good assumption?
Problem 6-16 (Algo)
The desired daily output for an assembly line is 420 units. This assembly line will operate 595 minutes per day. The following table contains information on this product's task times and precedence relationships:
| TASK | TASK TIME (SECONDS) |
IMMEDIATE PREDECESSOR |
| A | 35 | — |
| B | 40 | A |
| C | 70 | B |
| D | 10 | B |
| E | 40 | A |
| F | 30 | D-C |
| G | 20 | E |
| H | 15 | G-F |
b. What is the required workstation cycle time to meet the desired output rate?
c. Balance this line using the largest number of following tasks. Use the longest task time as a secondary criterion. (Leave no cells blank – be certain to enter “0” wherever required.)
d. What is the efficiency of your line balance, assuming it is running at the cycle time in part b? (Round your answer to 1 decimal place.)
W Shudent Hame -GaWM.I Ch 6 W 10/9 x anewconnectmheducation.com/low/conmecthtm Ch 6 W 109 Save& Exit Stund Help Submit 1 Problem 6-16 (Algo) The desired daily output for an assembly line is 420 units This assembly line will operate 595 minutes per day The fallowing table contains information on this product's task times and precedence relationships 30 TASK TIME IHMEDIATE (SECONDS) ponts TASK PREDECESSOR 35 Skipped 40 70 1A 40 D-C 20 E nons H. 15 G-F b. What is the required workstation cycle time to meet the desired output rate Beference SAOnds per unt Worksteion cycle time c. Balace this Ire using the largest number of fallowing tasks. Use the longest task tirme as a secondary criterion. (Leave no cells blenk be certain to enter “o” wherever required.) Idle Time Work Station Task Mc Graw Hil PIcy 1 of 1 Next T:03 PM Plype here to search Ei W Shudent Hame -GolWMJ Ch6 w 10/0 x newconnectmheducation.com/flow/conmecthim Ch 6 W 109 Save&Exit Snd Help Submit 1 G-l 15 b. What is the required workstation cycle time to meet the desired output rate? SAOnds per unt Workstelian cycle time 30 Skped c. Balance this Irre using the largest number of fallowing tasks. Usse the longest task time as a secondary criterion. (Leave no cells blank be certain to enter “O wherever required.) onic Work Statinn Idle Time Task References II d. What is the efficiency of your line balance, assuming it is running at the cycle time in part b? (Round your answer to 1 decimel place.) Elficiency 1 of 1 Prcy Next Ad1-03 PM 10/3/2019 ype here to search
An open settling tank shown in the figure below contains a liquid suspension. Determine the resultant force acting on the gate and its line of action if the liquid density is 850 kg/m3. The gate is parabolic as sketched, looking straight at the gate.
Attachments:
We are a leading academic writing company, which has been providing exclusive writing services for years.
With an exceptional team of professional academic experts in a wide range of subjects, we guarantee high-quality custom-written papers.
Hi there! Click one of our representatives below and we will get back to you as soon as possible.
Capture.PNG