Self-insurance is being considered for one portion of a chemical company. The fixed-capital investment involved is $50,000, and insurance costs for complete protection would amount to $400 per year. If self-insurance is used, a reserve fund will be set up under the company’s jurisdiction, and annual insurance premiums of $300 will be deposited in this fund under an ordinary annuity plan. AI1 money in the fund can be assumed to earn interest at a compound annual rate of 5 percent. Neglecting any charges connected with administration of the fund, how much money should be deposited in the fund at the beginning of the program in order to have enough money accumulated to replace a complete $SO,ooO loss after 10 years?

 

"Looking for a Similar Assignment? Get Expert Help at an Amazing Discount!"

ECE347Microcomputer EngineeringHW Delays and GPIO

Part 1)Write the code for a simple HC12 delay routine that runs for about 30ms. Show the timing analysis that supports the program logic and instructions.
Part 2)Note below the generic name of all of the registers that might be used when configuring and reading/writing an HC12 GPIO port.
Part 3)Which HC12 ports are available on ALL family members of the HC12?
Part 4)Write a simple P-code that describes blinking an LED with a 75% duty cycle; that is, on for 75% of the period, off for 25% of the period.

 

"Looking for a Similar Assignment? Get Expert Help at an Amazing Discount!"

Product Al Number of setups Machining hours Orders packed Number of products manufactured 1,000 150 600 Product BI 20 4,000 350 400 Berg Company incurs $320,000 overhead costs each year in its three main departments, setup ($20,000), machining ($220,000), and packing ($80,000). The setup department performs 40 setups per year, the machining department works 5,000 hours per year, and the packing department packs 500 orders per year. Information about Berg's two products is as follows: Using ABC, how much overhead is assigned to Product A1 each year? $160,000 $242,000 O$ 64,000 O $ 78,000 Question 17 (1 point) In a process cost system, product costs are summarized: O on job cost sheets. Oon production cost reports. O after each unit is produced. O when the products are sold. Question 18 (1 point) If 120,000 units are started into production there was no beginning work in process, and 40,000 units are in process at the end of the period, how many units were completed and transferred out? 120,000. 40,000 80,000 O 160,000.

 

"Looking for a Similar Assignment? Get Expert Help at an Amazing Discount!"

Q1) Test a sample data of your choice/provided by your tutor using t-test. Present the main results

Q2) Test a sample data of your choice/provided by your tutor using ANOVA. Present the main results.

Q3) Test a sample data of your choice/provided by your tutor using Chi-Square. Present the main results

NB:

Use appropriate references.

You have to submit all answers in one word file.

Make sure NO plagiarism

 

"Looking for a Similar Assignment? Get Expert Help at an Amazing Discount!"